|Register | FAQ's | New Posts | Today's Posts | Extras|
Dishwasher Cleaning poorly leaving food particles
Model Number: KUDS30FXSS Brand: Kitchen Aid Age: 5 - 10 years
Here's the lowdown:
Problem with poor clean, food particles stuck on plates and dirty water in bottom/smell started a few weeks ago. So far I have:
1.Checked for proper fill level and circulation - Good. (water inlet valve replaced June 2017 to fix low fill cleaning issue.)
2.Pulled flapper check valve and made sure of no obstruction- looked fine other than some small residual particles that are all in the lower area.
3. Checked and cleaned drain tubes from elbow to sink- all clear
4. Checked for continuity and free rotation on drain pump - good
5. checked for continuity on circulation pump- good (also no ground faults across terminals)
6. turbidity sensor was pretty dirty from calcium and soap residue - cleaned with CLR
7. chopper and screen assembly look normal
8. spray arms all clear
So the only thing I can find that wasn't in good order at least to my ability to check is the turbidity sensor. Is this enough to cause the problem? I thought the sensor could only extend or shorten the wash cycle time.
Any thoughts or input would be greatly appreciated.
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Samsung Dishwasher Food Particles Everywhere||luked3||Dishwasher Repair||0||05-24-2017 06:05 PM|
|dishwasher leaving grit and not cleaning||blue boy||Dishwasher Repair||0||07-15-2012 09:16 AM|
|Maytag dishwasher food particles in glasses||darrylgh||Dishwasher Repair||0||04-15-2012 06:35 AM|
|Tub fills with large food chunks, leaves food particles on glasses.||commendatore||Dishwasher Repair||3||06-05-2010 02:47 AM|
|Dishwasher leaves food particles||diamondbob||Dishwasher Repair||0||10-24-2009 04:23 AM|