|Register | FAQ's | New Posts | Today's Posts | Extras|
Dishwasher does not always start or stops mid cycle
Model Number: JDB2150AWP Brand: Jenn-Air Age: More than 10 years
Any selection on front panel
Push start button, light comes on and fills with water.
Will start sometimes and not others.
If it does Not start, then I can hear some sort of relay cutting in and out at the control panel before the light goes out.
If it does start it completes at least one cycle, drains water, loads water then will not continue with wash. Same as above, can hear a relay cutting in and out.
I have checked the float to make sure not stuck.
If I open the door after water fill, it is at right level.
Water seems hot enough if you open the door while it was running
Some things I have noticed.
Will always start first thing in the morning before any hot water has been run through the faucets, even though the evening before it would not start with multiple attempts.
On occasion it will run though to the end of all its cycles and the end light is lit.
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Washer numbers flash, stops after hitting start, stops mid cycle||BrianM245shopping||Washer Repair||1||07-09-2015 01:15 PM|
|maytag dishwasher promply stops after it fills and attempts cycle start..||morelandjoseph||Dishwasher Repair||0||07-24-2011 06:47 PM|
|Maytag SE 1000 washer stops mid cycle or won't start wash cycle||katyat||Washer Repair||1||09-11-2009 05:15 PM|
|Dishwasher skips the wash cycle and stops at the rinse cycle||jasporo||Dishwasher Repair||6||06-08-2009 05:11 PM|
|wash cycle stops 10 minutes after start||fullhouse||Washer Repair||1||03-20-2008 05:46 PM|