Rank: Member
Groups: Registered
Joined: 10/29/2009(UTC) Posts: 1
|
[FONT='Arial','sans-serif']I have a GE Profile dishwasher GSD4930X66WW. I'm getting a C1 error code. Checked all of the drain lines, the air gap is clear, pressed the Reset button and the disposal is empty.[/FONT] [FONT='Arial','sans-serif']What happens is, when in Normal Cycle, all the water pumps out in about 1 minute 5 seconds but the pump keeps on running until the C1 error is displayed, then the pump stops at 2 plus minutes and the washer moves on to the next part of the cycle. C1 remains on the Display.[/FONT] [FONT='Arial','sans-serif']If I press the Reset button and then start the washer in the Rinse & Hold cycle, all the water pumps out in about 1 minute 5 seconds, the motor runs for about 15 to 20 seconds then turns off with no error.[/FONT] [FONT='Arial','sans-serif']What is causing the drain pump to continue running after all of the water has been pumped out?[/FONT] [FONT='Arial','sans-serif']Thanks for your help.[/FONT] [FONT='Arial','sans-serif']Walt[/FONT]
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close