Rank: Member
Groups: Registered
Joined: 1/15/2011(UTC) Posts: 2
|
I have a Bosch dishwasher model shx45m.
The control board went bad and the service person came out and replaced it. After he did this the end of cycle alert got reset and was really loud. I went to adjust it and (I think) accidentally put it in test mode by pressing "power scrub" and "regular wash" when pressing the power switch instead of just "regular wash" .
Now when we go to use the washer the "quick wash" always says 116 and all the other cycles always say 199. Quick wash used to be a 30 minute cycle. I think it still only runs for thirty minutes but the display is incorrect.
How do I get the display to show the correct information? I tried unplugging it from the circuit breaker for 1 hour without any luck.
thanks
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close