Rank: Member
Groups: Registered
Joined: 10/3/2013(UTC) Posts: 1
|
Dishwasher was in storage about a year. Installed and run a cycle. Ran long and did not evidently get water as soap was still in tray at end of cycle. Now all I have is a blinking Heavy Cycle light. Read threads on resetting the control board by alternately pushing the Options HighTemp/Dry buttons 4-5 times and then Cancel. All that does is make the Rinse Only light to start blinking. Power to the dishwasher has been shot on and off several times (once for a day) but no change. Checked and wiggled all the connections on the control panel but no change.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close