Appliance Repair Forum

Appliance Repair Forum (
-   Dishwasher Repair (
-   -   Control board, etc., of Kenmore Elite (

Bill near Boston 07-25-2013 02:02 PM

Control board, etc., of Kenmore Elite
With either original or newly purchased control board, diagnostic test (i.e., touchpanel disconnected) fails: no spontaneous 2-minute motor spin.

Bill near Boston 07-25-2013 02:11 PM

P.S. to original "Default Control board, etc., of Kenmore Elite" post:

With touchpanel, etc., all connected, unit exhibits intermittent spontaneous behavior: a few lights lit, and brief motor spin. Sometimes pressing "Drain Off" button elicits expected motor spin. Multiple alternating "unlock/reset" button-push sequences have no effect. Once recently, with reconditioned control board, pressing "Normal Wash" didn't cause its LED to light, but then pressing "Start" resulted in several, but not all, normal wash steps.

All significant components within the unit (including main touchpanel matrix paths) that are testable with meter -- either voltage when unit is energized, or resistance when not -- seem within numbers on spec sheet (part no. 8051288).

All times are GMT -7. The time now is 05:52 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17