[goingjumping]

I have a Kenmore dish washer that seem to run and work but about 10 min into its cycle the water is over flowing on to the floor. If I open the door water seems to still be flowing out of the fill spout on the left side.

If I hit cancel and drain water still flows out for a little while but the washer does drain all the water from the base.

Is there some kind of fill valve that is jamming or not sensing the cycles?

Greg

[Gene]

Hi Greg,

Sounds like the problem is a bad water inlet valve under the dishwasher. Remove the toe panel and you'll access it.

- The water inlet valve Part number: W10158389

Gene.