Dishwasher Repair

Toddagod · #1 (**permalink**) 12-09-2012, 11:15 AM

Two things not happening on this old model.

Dishes are not being clean, due to the spray arms not getting enough water pressure to circulate?? Not sure.
Also noticed motor and solenoid connections are showing Continujity, but not the water valve connections.

Is the water valve suppose to provide a reading, and if so, how? Could this be my entire problem??

denman · #2 (**permalink**) 12-10-2012, 11:04 AM

Here are your parts.
Parts for GE GSD1200X66 Dishwasher - AppliancePartsPros.com

Open the door just after the first fill. Is there water in the tub?
Most units fill to just under the heater.

Yes, the water valve should have continuity.
Try a higher meter scale. If it still does not show continuity replace it,
The tub should not get any water if the valve does not have continuity.
Be sure to disconnect one side of the valve when measuring it. This prevents you from reading an alternate/parallel circuit path.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Spray arms	Bill M.	Dishwasher Repair	0	11-12-2011 07:23 AM
dishwasher spray arms	tom brennan	Dishwasher Repair	0	12-26-2010 09:52 AM
Upper Spray Arms	crehrer	Dishwasher Repair	3	11-13-2010 06:25 PM
Spray arms wobble; spray is weak	KevinVal	Dishwasher Repair	1	02-15-2010 02:03 AM
DW arms won't spray the water	rflores	Dishwasher Repair	1	08-07-2007 09:24 PM

spray arms idle

Dishwasher Repair

Two things not happening on this old model. Dishes are not being clean, due to the spray arms not getting