Dishwasher Repair

marycf · #1 (**permalink**) 01-28-2008, 07:02 AM

The "clean" light and the "light wash" light keep blinking. There is water in the bottom of the dishwasher that I can't drain. I tried turning power on/off but that didn't work. Any suggestions?
Mary

TexasCowboy · #2 (**permalink**) 05-02-2008, 05:27 PM

Quote:

Originally Posted by marycf

The "clean" light and the "light wash" light keep blinking. There is water in the bottom of the dishwasher that I can't drain. I tried turning power on/off but that didn't work. Any suggestions?
Mary

The Maytag diagnostic tips manuals says:

During Automatic Function Test, if a fault has been detected, the test will abort and 2 LED's will begin to flash. The CLEAN LED and:

Keypad 2 LED ("light wash") - Motor - low current.

I'd have someone check the voltage on the circuit your dishwasher is attached to make sure it is a at 120volts. Sounds like you have a brown-out voltage issue. Good Luck!

misterfixall · #3 (**permalink**) 05-02-2008, 08:18 PM

it appears your control board has failed

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
control lights flashing on dishwasher	rking11	Dishwasher Repair	43	11-24-2012 08:08 PM
Maytag Dishwasher lights flashing	TMo235	Dishwasher Repair	0	12-17-2009 10:49 PM
Dishwasher control lights flashing	Sam B	Dishwasher Repair	0	08-10-2009 02:41 PM
KitchenAid dishwasher lights flashing	Fred4242	Dishwasher Repair	0	05-09-2009 07:57 AM
Kitchen Aid Dishwasher lights flashing	sno-twister	Dishwasher Repair	5	10-28-2007 06:52 AM

Dishwasher lights flashing

Dishwasher Repair

The &quot;clean&quot; light and the &quot;light wash&quot; light keep blinking. There is water in the bottom of the dishwasher that

The "clean" light and the "light wash" light keep blinking. There is water in the bottom of the dishwasher that