|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Variation on the usual Bosch control board issue |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: SHU9956UC Brand: Bosch Age: 5 - 10 years
Have the usual "long cycle - timer stuck at 1 minute" problem. Thanks to all the info on the board, have been able to isolate the problem to my control board. Heater, thermostat, and flow switch working fine. The solder joints on the board looked fine. Added a little solder to the high voltage pins but did not fix the problem. Ran a test cycle with a volt meter connected to the heater relay input and got a nice 6.5V when the heater was supposed to go on but no 110 AC going though the relay. De-soldered the heating relay and the contacts are pretty fried inside. The relay is a SHC SRE303006. I have been trying to look for it on the internet but so far no luck in sourcing it. Any suggestions for a replacement or is my only option to replace the burnt relay by buying a $330 control board?
Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Control Board issue? | dlampy | Oven Repair (including Ranges and Cooktops) | 0 | 10-10-2011 08:38 AM |
| Whirlpool Double Oven Control Board issue | djalbright | Oven Repair (including Ranges and Cooktops) | 0 | 10-05-2011 07:53 PM |
| Control Board Issue | akonas38 | Dishwasher Repair | 0 | 02-18-2011 11:18 AM |
| GE JS968, Control Board Issue | dads95ss | Oven Repair (including Ranges and Cooktops) | 2 | 10-17-2010 07:36 AM |
| Bad Resistor in control board? Will this create a spin issue? | Brandon | Washer Repair | 3 | 03-03-2008 02:40 AM |