|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » is there a bearing |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
05-04-2012, 07:46 AM
|
|||
|
|||
is there a bearing
Model Number: PDW7300JO3CC Brand: GE Age: 1 - 5 years
The bottom (main) rotating arm runs unevenly and makes noise. The diagram shows a small "bearing" (washer?) (cost only $1.30) that is not in my dishwasher, and I'm wondering if it is possible that there never was one, or that the original disintergrated. I just recentally realized there is noise when running and it is from rotation of the rotating arm.
Should I replace it? Is it likely to stop the noise and unevenness? ecarpe Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
05-04-2012, 04:10 PM
|
||||
|
||||
|
It would not hurt to do it. It's also a good time to clean the fine filter screen.
Here are the breakdown diagrams and Replacement parts for General Electric PDW7300J03CC Dishwasher | AppliancePartsPros.com Gene.
__________________
Appliance Repair Expert in Orange County, California. Order Appliance Parts with 365-Day Hassle Free Return Policy - AppliancePartsPros.com
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do I tell if the Bearing is bad | VickiS | Dryer Repair | 5 | 08-14-2009 08:24 AM |
| Bad tub bearing | richappy | Washer Repair | 3 | 08-12-2009 08:38 AM |
| bearing kit | the pit | Washer Repair | 2 | 07-15-2009 08:53 PM |
| Possible bad bearing | porgas | Washer Repair | 1 | 06-24-2009 10:44 AM |
| Bearing | DANALVIN | Washer Repair | 0 | 12-27-2008 10:52 AM |
Linear Mode
