Dishwasher Repair

SpedG · #1 (**permalink**) 04-04-2012, 09:23 AM

Dishwasher powers on and cycles, but no water enters the tub. Most likely a bad water inlet valve?

Gene · #2 (**permalink**) 04-04-2012, 01:43 PM

Verify that the water supply is on and there is good water pressure to the water inlet valve.

Make sure the float (#15 at the diagram) is moving freely up & down and it is in down position.

If there is nothing wrong, check the float switch (#11) for continuity. The normal reading should be about 0 Ohms.

If there is nothing wrong, remove the wires from the water inlet valve solenoid and check for 120 VAC between these wires while the control calls for water.

If the reading is correct, replace the water inlet valve.

- The float switch Part number: AP2920872

- The water inlet valve Part number: AP2921090

Here are the breakdown diagrams and Replacement parts for Whirlpool KUDS25SHBS1 DISHWASHER | AppliancePartsPros.com

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GE Dishwasher won't fill	brotherleeroy	Dishwasher Repair	2	12-22-2011 05:38 AM
dishwasher does not fill	cmack	Dishwasher Repair	0	11-25-2010 09:18 PM
GE Dishwasher Will Not Fill	kodiak_dude	Dishwasher Repair	3	09-14-2010 10:42 AM
GE Dishwasher won't fill	ericfmiller	Dishwasher Repair	0	07-05-2010 11:21 AM
Dishwasher does not fill all the way	ljhnstn	Dishwasher Repair	1	05-27-2009 06:01 PM

Dishwasher won't fill

Dishwasher Repair

Dishwasher powers on and cycles, but no water enters the tub. Most likely a bad water inlet valve? Ads By