|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Whirlpool Quiet partner completes wash and starts again |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: gu980scgq2 Brand: -brand- Age: 5 - 10 years
Good Morning Everyone!
Maybe someone can help me figure this out..., when disshwasher completes wash cycle it starts again. when the cancel drain function is selected the washer drains and then fires back up in normal wash mode. The only yhing that stops it is locking the control console. I dont have the user manual so Im not sure if this is a feature or a defective control board? any help would be appreciated! Chuck Ads By Google Related Models |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
|
||||
|
Hi Chuck,
Did you replace the control panel yet? It was recommended by Joe earlier this month: NO LEDS (Lights) Gene.
__________________
Appliance Repair Expert in Orange County, California. Order Appliance Parts with 365-Day Hassle Free Return Policy - AppliancePartsPros.com |
|
|||
|
Changed console and board....,
Defective board maybe? The washer seems to run ok until the end; open the door to take dishes out and close the door, and it starts in "normal wash cycle". if you lock the controls at the beginning of cycle, it will stop at the end. If yoiu try and lock or unlock the controls while the washer is warm the console locks and flashes and does not respond until it cools off a bit or continue to play with it; seems like a sticky relay possibly? Your thoughts are appreciated! Chuck |
|
||||
|
Hi Chuck,
Check the thermistor (#37 at the diagram) for continuity. It should read 47-53 K ohms @ 77°F and 12-13 K ohms @ 140°F. Check it at both temperatures. - The thermistor Part number: AP3177333 Gene.
__________________
Appliance Repair Expert in Orange County, California. Order Appliance Parts with 365-Day Hassle Free Return Policy - AppliancePartsPros.com |
|
|||
|
Thanks Gene!
that one looks pretty challenging to get to! I know that the components in that pump do not come apart too easily, and advice on how to pull it apart; the last one i tried, the plastic parts were prety much fused together, it would be easier tao just swap the assembly! how do you get the thermister to that temp for testing? Thanks again chuck |
|
||||
|
Chuck,
You can easy access it by removing the bottom panel. The thermistor is attached to the pump housing from the bottom of the pump and secured with 2 screws. Gene.
__________________
Appliance Repair Expert in Orange County, California. Order Appliance Parts with 365-Day Hassle Free Return Policy - AppliancePartsPros.com |
|
||||
|
I never did it myself. Run the test at the room temperature first. It might be enough.
Gene.
__________________
Appliance Repair Expert in Orange County, California. Order Appliance Parts with 365-Day Hassle Free Return Policy - AppliancePartsPros.com |
|
See inside of your appliance - diagrams and part photos for virtually every model. powered by AppliancePartsPros.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quiet Partner II fills and drains, but will not wash | Leif S | Dishwasher Repair | 1 | 02-20-2012 03:04 PM |
| Whirlpool Quiet Partner II won't wash | Bernie999 | Dishwasher Repair | 1 | 02-20-2012 03:01 PM |
| Whirlpool quiet partner III | PeterK | Dishwasher Repair | 0 | 08-14-2011 05:26 PM |
| Quiet Partner III, Pots & Pans only cycle that starts | joemess | Dishwasher Repair | 0 | 02-20-2010 11:16 AM |