Rank: Member
Groups: Registered
Joined: 10/21/2008(UTC) Posts: 2
|
Kenmore Model 66513742K601 installed Dec'07 now will not start. Only indications of power are High Temp, Sani Rinse and Heated Dry Options will press and get green light. All other buttons dead. Door lock switches and fuse on control board all ohm check good. Door lock appears to engage switches OK. Checking door switches by depressing them both with door open still doesn't produce power. Should I suspect bad control board? Is there anyway to test it without replacing it with new? Any DIY diagnostic that I have over looked?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close