Rank: Member
Groups: Registered
Joined: 12/25/2007(UTC) Posts: 10
|
Hello -
I replaced twice a door seal in my 2 1/2 years old Kitchen Aid dishwasher and they continue falling off when opening the door. The problem starts upon +/- 20 washing cycle. The original seal got broken after around two years of use. The replacements received from AppliancePartsPros were easy to push into the groove, I thought a bit too easy. Also, visually the original seal appeared thicker. However, the Tech Support Staff informed me the parts I got were correct. I raised the issue to their attention today again, and the only advise I got was to ask for an advance on the Forum.....
So, any ideas? Should I be using some sort of glue or just take a mallet and hummer the groove to hold the seal....?
Parts #s: Dishwasher: KUDS03CTBL3 SN: FY0604341 Type: 577-0
Replacement Part:
AP3969232 (W10112096) - GASKET
Thank you,
Volant
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close