Rank: Member
Groups: Registered
Joined: 12/18/2011(UTC) Posts: 3
|
I lost power entirely, replaced thermal fuse and ran for about one week. Purchased and installed new active vent (noted significant corrosion at wire connections), installed new user interface but left same control board in place. Lights are noted on control panel when depressing buttons but dw does not start up despite lights on. What's left to change....ribbon cable on control board, switch on latch, or heater?
The last run was a rinse cycle and the one before that was sani rinse. I did purchase heater replacement and wonder if that's next.
thanks for review. parts have been rapidly delivered despite Christmas Holiday.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close