Dishwasher Repair

dawrph · #1 (**permalink**) 12-11-2011, 08:24 AM

So my dishwasher stopped heating the water adequately and an error code "2" came up after the self test. Repair guy charged me $80 to tell me the control board was "burnt" and needed to be replaced. Total cost (including his "diagnostic" fee) would be $310. Turns out it was only a burnt solder joint on the circuit board and for $25 I fixed it myself. It was very easy. I think Bosch is aware of the problem but wants to ignore it and maybe it'll go away. If you have the same issue, I can walk you through the repair.

ApplianceJunk · #2 (**permalink**) 12-11-2011, 08:32 AM

Hi,

Great info. It's always a good idea to take a minute and look for a bad solder connection before replacing any electronic board.

I often find broken solder joints at the plugs that the wire harness plug into.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
bosch dishwasher problem	pattyshealey	Dishwasher Repair	0	12-07-2011 11:14 AM
Bosch dishwasher heating problem	ChrisBosch	Dishwasher Repair	0	09-08-2011 04:30 PM
Bosch dishwasher problem	fyocca	Dishwasher Repair	0	09-10-2010 07:55 AM
Bosch Heating Problem Clarification	Greg in Sudbury	Dishwasher Repair	1	08-19-2009 06:08 PM
Problem with Bosch dishwasher	Cartoony	Dishwasher Repair	1	04-03-2008 11:40 AM

Bosch dishwasher heating problem

Dishwasher Repair

So my dishwasher stopped heating the water adequately and an error code &quot;2&quot; came up after the self test. Repair

So my dishwasher stopped heating the water adequately and an error code "2" came up after the self test. Repair