Dishwasher Repair

jroske · #1 (**permalink**) 10-18-2011, 11:50 AM

The wash cycle works but then stops. Not sure if the rinse cycle is working but When it is done washing (or rinsing) the indicators lights go off. Normally it would indicate drying or complete. The dishwasher can not be restarted for a while either. After the wash cycle is complete all lights die for about 30 minutes until the dishwasher is restarted. Could it be the control board out? Thanks in advance.

Gene · #2 (**permalink**) 10-18-2011, 01:38 PM

Very likely the problem is a bad control board.

- The control board Part number: AP4362730

Here is the Tech sheet.

Here are the breakdown diagrams and Replacement parts for FRIGIDAIRE FDB2000RFS1 Frigidaire/dishwasher | AppliancePartsPros.com

Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cannot finish wash cycle	hada	Dishwasher Repair	0	11-11-2010 02:12 PM
dishwasher runs but wont finish cycle	scottyy45	Dishwasher Repair	0	10-19-2010 06:39 PM
Kenmore/Whirlpool Dishwasher won't finish drain cycle	grisatre	Dishwasher Repair	0	03-21-2009 10:27 AM
LG dishwasher takes forever to finish cycle	Pat2622	Dishwasher Repair	2	02-24-2009 03:24 PM
Dishwasher does not finish cycle	wooody04	Dishwasher Repair	0	10-22-2008 11:20 AM

Dishwasher does not finish cycle

Dishwasher Repair

The wash cycle works but then stops. Not sure if the rinse cycle is working but When it is done