|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » No power |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
10-07-2011, 12:49 AM
|
|||
|
|||
No power
Model Number: 665.5752000 Brand: Kenmore Age: 5 - 10 years
What would I test on the power panel to see if it's faulty? I have power to the door switch and also power to the fuse. Don't want to order an expensive part if not needed. Thanks for any input.
Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
10-07-2011, 08:59 AM
|
||||
|
||||
|
Hello. The model number you provided is not working. If there is power to the fuse, you will need to unplug the wires to the fuse and test the terminals on the fuse. It should read closed for continuity. If open, you will need to replace it. You can test this with a multi-meter [AP3873826]. Here is a link on how to use a multi-meter. Hope this helps. How To Check Continuity With Ohmmeter
__________________
Thanks for allowing AppliancePartsPros.com to assist you, Jeff K. / APP TEAM Find Appliance Parts at AppliancePartsPros.com - Largest inventory in the U.S. with 91% of all in-stock orders delivered within 2 business days. Thousands of photos and diagrams make it very easy to find the right part. Enter your appliance model here.
|
|
10-07-2011, 09:10 AM
|
||||
|
||||
|
Quote:
In most cases you program the diagnostic test mode by pressing the buttons in this sequence: High Temp Wash, Air Dry, High Temp Wash, Air Dry The control should run a test cycle in a matter of a few minutes. Your Technical Data Sheet and wiring diagram should be attached to the back side of the lower kickplate, in a plastic bag, and you should be able to verify and program the test mode properly. 
__________________
Thanks for allowing AppliancePartsPros.com to assist you, Joe M. APP TEAM Find Appliance Parts at AppliancePartsPros.com - Largest inventory in the U.S. with 91% of all in-stock orders delivered within 2 business days. Thousands of photos and diagrams make it very easy to find the right part. Enter your appliance model here.
|
|
10-08-2011, 12:15 AM
|
|||
|
|||
|
Quote:
|
|
10-10-2011, 06:41 AM
|
||||
|
||||
|
Quote:
Start with a control panel/keypad assembly, That component is more susceptible than the control board. Good Luck,
__________________
Thanks for allowing AppliancePartsPros.com to assist you, Joe M. APP TEAM Find Appliance Parts at AppliancePartsPros.com - Largest inventory in the U.S. with 91% of all in-stock orders delivered within 2 business days. Thousands of photos and diagrams make it very easy to find the right part. Enter your appliance model here.
|
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| no power but does have power to unit can here a very faint beeping sound comeing from | anthony manning | Dryer Repair | 0 | 10-05-2011 08:45 PM |
| Maytag Gemini No Power to Oven/Power to Stove | crashbowman | Oven Repair (including Ranges and Cooktops) | 2 | 01-12-2011 09:49 AM |
| power surge damaged power pack,replaced,compressor and condenser fan still not runnin | shillion | Refrigerator & Freezer Repair | 0 | 11-16-2010 01:38 AM |
| Maytag Neptune Dryer - no power at all after power cord | poli | Dryer Repair | 0 | 07-09-2010 07:46 AM |
Linear Mode
