|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Maytag Dishwasher low water level |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
09-26-2011, 12:20 PM
|
|||
|
|||
Maytag Dishwasher low water level
Model Number: MDB6000AWW Brand: Maytag Age: More than 10 years
I have a Maytag MDB6000AWW dishwasher. I determined that the water valve was faulty so I replaced it. I am still finding that on occasion it will not fill to the proper water level once the pump starts. I suspect that it may be the timer at fault. The micro switches and float system seem fine. My thinking is that there is a contact in the timer that will allow the water level to fill during the wash cycle and that this may be faulty. Any thoughts or experiences that can be shared would be great.
Just to be clear, the dishwasher does fill, but occasionally will not "top up" once the pump starts leaving less than the required amount of water to properly clean. Maybe it should fill initially to a higher level? Thanks, Rob Ads By Google Related Models 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Maytag Centennial water level sensor | MobileAL | Washer Repair | 1 | 07-06-2011 02:41 PM |
| Bosch dishwasher water level | dsovetsky | Dishwasher Repair | 0 | 02-20-2010 10:19 AM |
| Maytag water level issue | jonmaytag5537 | Washer Repair | 1 | 11-09-2009 06:35 PM |
| Trouble shotting a Maytag Water Level Switch | Toymaker49 | Washer Repair | 1 | 02-06-2009 08:31 PM |
| Maytag Washer Inlet valve - water level switch | reisman | Washer Repair | 0 | 10-23-2007 08:36 PM |
Linear Mode
