Dishwasher Repair

jap1561 · #1 (**permalink**) 04-22-2009, 10:59 AM

My dishwasher fills with water and appears to run through its cycles, but no water is spraying through the spray arms, upper or lower. Then it drains as though done.

Help!

Blipbeep · #2 (**permalink**) 06-24-2011, 12:27 PM

For those finding this thread on Google...I had a similar problem with my Kenmore 587.1525 dishwasher. I could start the wash, the washer would fill but the rinse cycle wouldn't initiate.

For me it ended up that the control board wasn't sending the spray/rinse signal to the motor. I decided to reboot the washer so I cut the power (in my case at the circuit breaker) and waited for a few minutes. When i flipped the power back on two of the front panel lights flashed. I pressed cancel and started a new wash. Thankfully everything worked correctly.

Cutting the power also fixed a problem where the panel was completely unresponsive.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Kenmore dishwasher doesn't spray/clean well	cbprincipal	Dishwasher Repair	3	02-20-2010 05:36 PM
Kenmore Dishwasher Middle spray arm problem	TJ Bibbs	Dishwasher Repair	0	11-05-2009 02:42 PM
Kenmore/Whirlpool Spray Arm Removal	mdcsd	Dishwasher Repair	2	05-12-2009 12:41 PM
Dishwasher top spray arm	r28shultz	Dishwasher Repair	0	10-07-2007 11:48 AM
kenmore spray arm wont spin	bh77521	Dishwasher Repair	2	09-14-2007 03:03 AM

Kenmore Dishwasher won't spray

Dishwasher Repair

My dishwasher fills with water and appears to run through its cycles, but no water is spraying through the spray