|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » loud noise at beginning and now nothing |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
11-25-2007, 07:35 PM
|
|||
|
|||
loud noise at beginning and now nothing
Model Number: 15872000 Brand: Kenmore Age: 1 - 5 years
I started up our dishwasher and after a minute or two was a loud POP and the breaker was thrown. Every time I reset the breaker it just instantly throws back. There also was a burnt electrical smell at the dishwasher when this happened. I open it up and there was about 2 inches of water on the bottom and now i can not power it up due to the breaker will not stay reset. Ant suggestions on where to start would be great.
Thank You Joe     
|
|
11-25-2007, 08:24 PM
|
|||
|
|||
|
Power
make sure your power is off. then take bottom panels off. their is a little box where your incomung power hooks to the dishwasher. check that for a bad connection. then look over your wiring for any thing that looks like it got hot.
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud Noise | romeroom | Dishwasher Repair | 5 | 01-28-2008 01:22 PM |
| Loud squeaking noise during spin cycle | thwillis99 | Washer Repair | 2 | 11-14-2007 10:27 PM |
| Loud Noise During Operation | ctnr | Dishwasher Repair | 1 | 11-14-2007 09:32 AM |
| Makes loud clunking noise | drdesl2 | Washer Repair | 4 | 09-30-2007 02:51 PM |
| Makes loud noise when spinning | waggie | Washer Repair | 0 | 09-03-2007 02:05 PM |
Linear Mode
