Dishwasher Repair

Avogel · #1 (**permalink**) 08-01-2007, 10:36 AM

The original problem is when you start a wash cycle you hear the solenid click but the washer doesn't get water inside. You can restart it 3-5 times before it will finally get the water to the washer. I was told it was the panel switch and the control board. I'm curious which is the more probable culprit of the two.

Gene · #2 (**permalink**) 10-03-2007, 10:47 PM

Hi Avogel

The first thing I would do is to check the water inlet valve. remove the bottom panel and check the solenoid for a continuity, then check if the 120V is coming to the water inlet valve at the fill up time. If the power is coming then the water valve is bad and has to be replaced.
If there is no power then check wires and if everything else fine then replace the control board.

- The part number for the water inlet valve AP2921090

- The part number for the control board AP3133674

Good luck.
Gene.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
dryer wont start	phyllis	Dryer Repair	5	10-21-2008 03:24 PM
Dryer stops running after letting off the Start button	Andy	Dryer Repair	10	08-01-2007 10:56 PM
Dryer motor is noisey and sometimes humms and doesn't start	Tudeman	Dryer Repair	2	07-20-2007 04:20 PM

No water during start-up cycle

Dishwasher Repair

The original problem is when you start a wash cycle you hear the solenid click but the washer doesn't