Rank: Member
Groups: Registered
Joined: 7/24/2011(UTC) Posts: 1
|
My Kenmore dishwasher was acting erratically on cycles so I replaced the control panel. Now it seems to cycle correctly but does not refill after the first cycle. I have checked the fill valve, no continuity so I am looking to replace it but I checked the voltage from the control panel and only got ~ 72 volts. Did I not have good contact with the voltmeter or am I going to have problems with my new control panel? Hepful advice appreciated
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close