|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » No water supply for wash cycle |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
11-20-2007, 02:30 PM
|
|||
|
|||
No water supply for wash cycle
Model Number: JDB3910AWQ Brand: Jenn-Air Age: 5 - 10 years
Dishwasher goes through the motions, but dishes remain dirty and detergent is not consumed. After investigation, water is added and drained during prewash cycle, but no water is added during wash cycles. Solenoid on intake valve functions properly when jumping power. Float switch has continuity when appropriate. Wash cycle functions normally when adding water manually. Even replaced circuit board... Any thoughts on what else to check?
    
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kenmore - Water supply problem | wdj03 | Refrigerator & Freezer Repair | 3 | 09-23-2008 11:40 AM |
| Dishwasher skips the wash cycle and stops at the rinse cycle | jasporo | Dishwasher Repair | 1 | 11-16-2007 06:12 PM |
| Agitator squeeks during wash cycle | poskas | Washer Repair | 0 | 08-22-2007 10:05 AM |
| Can not select wash cycle - stuck on scrub wash | luke | Dishwasher Repair | 0 | 08-20-2007 09:38 AM |
| quick wash cycle | vicky | Washer Repair | 1 | 07-23-2007 03:55 PM |
Linear Mode
