|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Replaced Motor and now it doesn't clean |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
11-15-2007, 05:55 PM
|
|||
|
|||
Replaced Motor and now it doesn't clean
Model Number: HDA3230Z04WW Brand: Hotpoint Age: 1 - 5 years
I replaced the motor in this Hotpoint a couple of months ago with the new quiet motor from GE that replaced many models. Every since I replaced the motor it does not clean like before and it doesn't seem to drain; there is usually 2-3 inches of water left in the bottom at the end of the cycle. If you start the cycle again it will begin to drain the water left in the bottom.
     
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| replaced latch assy- now won't run | Rick P | Dishwasher Repair | 1 | 10-19-2007 03:51 AM |
| Dishwasher N/F; Electronic Control Replaced | Strong | Dishwasher Repair | 0 | 09-20-2007 08:29 PM |
| Ice maker still leaking - Just replaced fill valve | Adam80 | Refrigerator & Freezer Repair | 1 | 09-12-2007 08:09 PM |
| Replaced the igniter and there is still no heat in my oven??!! | Ruben | Oven Repair (including Ranges and Cooktops) | 1 | 08-21-2007 11:44 AM |
| never replaced a drive belt before | stonebuster | Washer Repair | 0 | 08-10-2007 05:23 PM |
Linear Mode
