|
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » maytag dishwasher |
|
|
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
|||
|
Model Number: mdb6600aww Brand: Maytag Age: 1 - 5 years
Dishwasher fills and pump seems to run but no water is moving.I checked the filter, impeller and coupler all seemto be a-1 condition.Could this be a bad capacitor?
|
|
|||
|
It may be just your drain pump working and not the main motor. In the wash mode, I would check for current to the start winding(the red wire to motor) and current to the run winding(yellow wire)If either of these is not drawing current, you have a bad control module.
It is possible both motor and control module is bad. It is hard to test motor without a motor tester. I would just replace the control module.
__________________
- |
|
|||
|
I have the same model maytag MDB6650AWW. Dishwaher has power but cycle stopped cold in the middle of a drain cycle (I think - still some water in the tub). No electronic feedback to the key pad. Assuming its either the keypad itself or the control panel. Any feedback would be helpful.
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
|
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Maytag dishwasher not working at all .. | rtc | Dishwasher Repair | 5 | 01-04-2008 06:19 PM |
| Maytag dishwasher on the blink | Sandra | Dishwasher Repair | 0 | 10-21-2007 11:42 AM |
| Maytag dishwasher stuck on drain cycle | ak47jazzfan | Dishwasher Repair | 3 | 10-15-2007 11:35 PM |
| Maytag Portable Dishwasher Problem | carr65 | Dishwasher Repair | 0 | 09-06-2007 01:55 PM |