|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » GE profile DW start function does not work |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
10-31-2007, 06:22 PM
|
|||
|
|||
GE profile DW start function does not work
Model Number: PDW9800 Brand: GE Age: 1 - 5 years
GE PDW9800 Profile DW. Start button on the HMI won't work. This happened sometime after a wash cycle was complete earlier in the day. All other functions work. Get an 'engage' beep with door opening and closing. Tripped breaker a few times to reset, goes to normal cycle, same issue.
None of the status LED's are lit either.     
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| oil leak from under ge profile washer | husker | Washer Repair | 0 | 10-14-2007 01:21 PM |
| GE profile blew up | bettye | Microwave Repair | 2 | 10-12-2007 06:05 PM |
| Wont start/start switch replaced | awilliams197 | Dryer Repair | 1 | 09-18-2007 02:33 AM |
| GE Profile Cas range | PJCIII | Oven Repair (including Ranges and Cooktops) | 3 | 08-27-2007 10:19 AM |
| GE Profile Control Board ??? | markham | Oven Repair (including Ranges and Cooktops) | 4 | 08-21-2007 05:15 PM |
Linear Mode
