|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » No wash dishwasher |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
10-28-2007, 10:09 AM
|
|||
|
|||
No wash dishwasher
Model Number: GU1200XTLB1 Brand: Whirlpool Age: 1 - 5 years
The washing cycle does not function. It pumps water in and out but skips the wash cycle on more than one choice of cleaning. How do you determine if the problem is the Electronic Control? How do you get to it to replace it?
    
|
|
10-30-2007, 05:28 AM
|
|||
|
|||
|
You will have to pull the inner panel off to get to the control module. Disconnect
motor plug and press the latch to turn dishwasher on and select the failing cycle. If no voltage to motor, you have a bad control module. You will need the service sheet to find the right pins on the control module.This is located behind the bottom kick panel.You have a two wire sidewinder motor without a start relay so this makes things simple to check motor voltage.
__________________
- Last edited by richappy : 10-30-2007 at 05:32 AM.
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dishwasher fills and drains and runs trough cycles but doesnt wash | ryan6663 | Dishwasher Repair | 1 | 10-24-2007 05:11 PM |
| Sears Ultra Wash Dishwasher | jfreder | Dishwasher Repair | 1 | 10-05-2007 05:13 AM |
| Little Water Wash | Kip Harkness | Dishwasher Repair | 1 | 10-03-2007 07:52 PM |
| Can not select wash cycle - stuck on scrub wash | luke | Dishwasher Repair | 0 | 08-20-2007 09:38 AM |
| quick wash cycle | vicky | Washer Repair | 1 | 07-23-2007 03:55 PM |
Linear Mode
