Rank: Member
Groups: Registered
Joined: 3/26/2011(UTC) Posts: 1
|
I replaced the soap dispenser in my kitchenaid dishwasher today. When it was put back together, the 4 hour delay light is lit continuously and the Normal light is blinking. I try to clear it, with no success. I closed the door and the dishwasher ran for about a minute, then stopped. It's been about 3 hours and nothing is happening. Did I short out the control panel? Could I have installed the wires to the solenoid incorrectly? I tried switching them. Same result.
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close