Dishwasher Repair

meyerweb · #1 (**permalink**) 10-11-2007, 06:56 PM

This should be a trivial issue, but it's keeping the d/w from working correctly.

The hinge on the dispenser got popped, and the spring that holds the lid open got "unsprung." I can see how it's supposed to fit, but for the life of me I can't figure out how to get it back on so the ends of the spring put tension on the door.

If anyone's done this before, and can offer any "secret" tips, I'd sure appreciate it.

Many thanks,

Bob

richappy · #2 (**permalink**) 10-12-2007, 03:11 AM

You need to pull the door off and rotate spring till it puts pressure on the door to close, then remount door.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Kenmore - Water supply problem	wdj03	Refrigerator & Freezer Repair	3	09-23-2008 11:40 AM
detergent release latch	linjarob	Dishwasher Repair	1	10-03-2007 10:08 PM
Detergent dispenser	mikewhitetx	Dishwasher Repair	1	08-10-2007 10:20 PM
whirpool frige water dripping from dispenser	chaspitifer	Refrigerator & Freezer Repair	1	08-09-2007 05:53 AM
Need clean cloths, whirpool washer	smurzynski	Washer Repair	1	08-06-2007 05:50 PM

Kenmore/Whirpool detergent cup (lid) problem

Dishwasher Repair

This should be a trivial issue, but it's keeping the d/w from working correctly. The hinge on the