Dishwasher Repair

ncpitman · #1 (**permalink**) 09-23-2007, 08:20 AM

My dishwasher is dead. I have no LEDs lit on top of the door to begin the cycle. I've pulled the front apart and have confirmed voltage to the input side of the Macrotemp control module. This is the only place I can see where voltage comes in before it's distributed to the control panel and then on to the LEDs. I assume when that part is working properly it's shorted I should have voltage on either side and/or read very little voltage when measuing across both terminals. When it breaks, it's open and I can only measure voltage on one side and/or the 110 voltage across the terminal. Am I on the right track and should replace this module or may I jumper pass it to confirm?

ncpitman · #2 (**permalink**) 09-27-2007, 07:57 PM

Thank you for all the feedback. Couldn't fixed it without you. Yes, it was the Macrotemp.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dishwasher dead	sonnydaze69	Dishwasher Repair	4	02-24-2010 02:50 PM
Dead dishwasher	flgentrys	Dishwasher Repair	3	06-01-2009 05:20 AM
Dishwasher is dead	Glenvan	Dishwasher Repair	4	11-23-2008 09:18 PM
Dishwasher Dead	monist	Dishwasher Repair	1	09-18-2008 06:06 PM
dishwasher is dead	rchiga	Dishwasher Repair	1	09-13-2007 02:16 AM

Dishwasher Dead

Dishwasher Repair

My dishwasher is dead. I have no LEDs lit on top of the door to begin the cycle. I've pulled