Rank: Member
Groups: Registered
Joined: 8/29/2010(UTC) Posts: 1
|
I have a Bosch 3036 UC/UC12 that is slower through the cycles. The cycle nob will stop rotating at approx 6 O'clock position. I have seen the controller board post about the burnt connection. Where is the controller board located? Do you think this is our problem?
|
|
|
|
Forum Jump
You can post new topics in this forum.
You can reply to topics in this forum.
You can delete your posts in this forum.
You can edit your posts in this forum.
You cannot create polls in this forum.
You can vote in polls in this forum.
Important Information:
The AppliancePartsPros.com uses cookies. By continuing to browse this site, you are agreeing to our use of cookies.
More Details
Close