|
|||
 |
|||
| Register | FAQ's | New Posts | Today's Posts | Extras |
| » Obsolete Microprocessor Board |
 |
By reading any content on this site you agree to AppliancePartsPros.com, Inc. disclaimer and Terms of Use. |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
06-19-2010, 08:08 AM
|
|||
|
|||
Obsolete Microprocessor Board
Brand: Kenmore Age: 5 - 10 years
P/N 8534866 was replaced by P/N 8564542 and the new board is missing a device where two wires plug in with stacons. The device on the old board is titled Microtemp. It would be located right above P2_alt and C13 if it were on the new board.
What do I do with the two wires that were plugged into Microtemp on the old board? Ads By Google 
|
|
See inside of your appliance - diagrams and part photos for virtually every model.
powered by AppliancePartsPros.com |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Replacement Part for Obsolete Wall Heater? | kholthe | Heating, Ventilation, and Air Conditioning (HVAC) | 0 | 03-09-2010 05:39 PM |
| Replace Oven Gasket for obsolete part | stoveandi | Oven Repair (including Ranges and Cooktops) | 0 | 12-02-2009 05:03 PM |
| Substitute for Obsolete Oven Door Part-Help Please | egarts | Oven Repair (including Ranges and Cooktops) | 0 | 11-07-2009 05:09 PM |
| microprocessor, control panel or blower motor/fan? | vikingwings | Microwave Repair | 0 | 04-26-2009 02:12 PM |
| Obsolete Thermadore Part Needed | PaulH | Oven Repair (including Ranges and Cooktops) | 5 | 08-04-2008 09:36 AM |
Linear Mode
