View Single Post
  #9 (permalink)  
Old 11-22-2013, 07:48 AM
Appliance Ninja Appliance Ninja is offline
Senior Member
Join Date: Nov 2013
Posts: 957
Appliance Ninja is on a distinguished road

Make sure the tubing is pushed in very tight. If you removed plastic compression nuts to accommodate the new valve fittings, you may need to cut that tubing back just a bit so you have a smooth surface for the rubber O ring in each of the fittings to seal around. If you need to remove those lines, be sure to hold in that plastic washer then pull them out. Do not forcefully pull them out or the valve will be damaged.
Reply With Quote

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17