[rkstjarz]

Gas dryer drum starts and turns on all cycles. No flame on automatic cycles.
On the 'Timed Dry' cycle the ignitor glows, the burner flames on then shuts off after about one minute. The coils were replaced. The flame sensor, control thermostat and high limit thermostat all appear to have continuity.
Readings on timer in off position (not sure if these have any significance):
X to A: no reading
X to B: 3.5
X to C: 3.5
X to S: 3.5
X to TM: 2.3
B to S: 1.3
B to C: 1.3
C to S: 1.3
Test connector: 4.6
Meter lead to lead: 1.3
Will a defective timer cause the burner shut-off?
Thanks in advance for any ideas.