[cvarble]

Hey guys-
I'm hoping someone can help me or point me in the right direction.

Problem: the washer goes through the cycle and freezes on the last minute. Its finished, the water drains, but the door on the washer won't unlock.

The first problem code was F20- low or no water pressure. After many steps, I cleaned out the water intake in the back, yes, it was goobered up pretty badly.

The door STILL won't unlock so I was just positive that the door lock mechanism was bad. I replaced it. STILL when I do the diagnostic cycle, it finishes at 'rinse and spin' meaning check door lock mechanism.

I was able to put it through a 'rinse and spin' cycle, the water did fill the tub and drain out, but it still froze with one minute to go and the door didn't unlock.

Do any of you guys have any ideas on where to go from here?

Thanks for your help- I appreciate it!

Christina