So, the other day I noticed my clothes were still soaked when the washer was done. After a little exploring, I noticed it would not spin in any setting. Didn't check to see if it was agitating properly (probably should have checked that too before disassemble
).
Upon pulling out the motor, I notice the coupler had the teeth sheared off of the motor end. I am assuming this is the problem. Have a new coupler on the way.
The only other issue I am concerned about at this point, is that when I had the machine laid over on it's back, the tranny leaked about 3, maybe 4 ounces of gear oil. I really don't want to buy a bottle or take the tranny out if I don't need to. My question is, is there still enough oil in the tranny? Or do I need to add a few more ounces back in? It looks like the only way to do that is pulling the tranny apart, which I don't want to do... I read somewhere that there is between 12 and 15 ounces in there when full. Will the small amount I lost be missed??????