Reassembled front load now water smells moldy
A couple months after replacing rear bearing and seals we now have the moldy smell problem that these machines are pron to but never had before. I didn't replace the gasket between the barrel half's but there no leaks there. The rubber boot looked good and is glued back into place on the door face. The only thing I can see that maybe causing an issue is there's still water in the pump boot and the water exit line at the end of the spin out. Maybe a pump issue?
Ads By Google
Related Models
Last edited by christo83 : 09-23-2012 at 04:55 PM.
Reason: wasn't able to post before, first line was just a test
|