Thread: Ice Maker
View Single Post
  #3 (permalink)  
Old 09-19-2012, 05:25 AM
kcsims kcsims is offline
Junior Member
 
Join Date: Sep 2012
Posts: 3
kcsims is on a distinguished road
Default

The arm is down. I did jump T and H and it did cycle through. Even without doing that, the ice maker does get water into the tray and properly freezes it. It just never cycles through to actually eject the ice cubes.

The icemaker I am using is new, I just installed it. I am wanting to replace the wire harness too, but there is no obvious way to remove it from the freezer wall. There is no clip or anything to push. How do I remove them without damage?

Is there anything that would cause the ice maker to not cycle and eject the frozen cubes?

Could the wire harness have a blown fuse and possibly cause this?

Last edited by kcsims : 09-19-2012 at 05:33 AM.
Reply With Quote
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17