Thread: Oven controller
View Single Post
  #2 (permalink)  
Old 09-11-2012, 03:29 AM
denman denman is offline
Senior Expert
APP Volunteer
Join Date: Feb 2008
Posts: 19,638
denman is a splendid one to behold

Here are your parts
Replacement parts for Frigidaire FES366ECC Frigidaire/electric Range |

Here is your wiring diagram.

Since it is usually pretty tight in the control panel area I personally do not like doing live tests in this area. Too large a possibility of a arc/spark and/or getting hurt.

I would unplug the unit and check the wires to the board and to the elements using resistance/ohms.

Also disconnect the oven sensor at the board and check it. It should be around 1100 ohms. This circuit has a circuit breaker in it that may have popped. I am not sure if the control board would give an error if it sees an open sensor so perhaps that is the problem re: it thinks the unit is already at high heat so does not turn on the elements. I am also not sure but some of theses breakers have a button between the connectors that pops out so they can be reset.

If everything checks OK I would replace the control.
Reply With Quote

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17