View Single Post
  #37 (permalink)  
Old 01-26-2009, 03:16 PM
plink49 plink49 is offline
Junior Member
Join Date: Aug 2008
Posts: 6
plink49 is on a distinguished road

Thanks Gene,

Other than the fact that whoever designed the location of the mounting bracket for the burner should be put in front of a tribunal, the replacement of the igniter went very smoothly. The bracket with the 2 screws with hex heads is where you can't get a socket or wrench to undo them and took me 3 times a long to remove/replace that bracket than the remainder of the job. I wound up replacing the screws with stainless steel sheet metal screws with phillips heads so they can be removed at least a little bit easier the next time.

This forum is great!
Reply With Quote

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17