it will occasionally spin out , but most often it doesn't centrifuge the water out like it should.
If we catch it , lift the lid and close it again the machine will 'catch' and start to spin. After reading some of the posts here - I suspect a clutch assembly...
Any input on what the issue is??
I have ruled out a lid switch , as the motor always runs. I have NOT disassembled the machine , but figured that was the most likely culprit .
(BTW the last time Wife used it some water leaked - but I think it was from an unbalance overfill)
Whirlpool
LSQ9010LW2
S/N CP4713235
ANY INPUT PLEASE???
Thanks!!
Robert