View Single Post
  #3 (permalink)  
Old 09-25-2011, 05:39 PM
richappy richappy is offline
Senior Expert
APP Volunteer
Join Date: Sep 2007
Location: State College, Pa.
Posts: 9,586
richappy is a splendid one to behold

Go to web site for complete info on this fine dependable care washer.
You will need to purchase the special spanner wrench for the tub nut (left hand thread) and tub bearing set AP4372971 and seal kit AP3538707
You will also need a steel rod to pound up and out the old sleeve bearing stuck on the tranny shaft. When done, oil the bearing with light non-detergent oil. A routine job for a good mechanic.
You will need 3 hours for the job, I quoted $180 for the job but probably not enough.
Reply With Quote

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17