View Single Post
  #7 (permalink)  
Old 08-06-2011, 03:04 PM
smjbrules smjbrules is offline
Junior Member
 
Join Date: Jul 2011
Posts: 4
smjbrules is on a distinguished road
Default

Okay, so I ordered the board and installed it. The black wire put back on the "on" terminal on the heater relay and the blue on the "common". It read 120 on the "on" and 120 on the "common" terminal (when the blue wire was not attached). So I tried to run the dryer and got the same error as before. That's when I asked for the wiring to the heating element. I had it hooked up right. So I went back to the board and now I'm getting 120 going in and the common terminal is reading no voltage. I may just be in over my head. Did I burn the new board up?!!?!?
Reply With Quote
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17