Originally Posted by debryan
OK. I ordered the part.
I was a little concerned that the part #s were different but the part looked the same.
My handyman assured me that it was the right part, but needed to get 2 additional hoses to make it fit my Whirlpool Conquest.
After all, I still have no ice.
Water still fine.
Remember that my water was off for several hours and all lines dry.
You've got me lost and wonderring. or your handyman does.
You did order and recieve this part number ?
Part number: AP3160649
Everything you needed was in the fill valve kit, including the extra tubing,and an instruction sheet.
Why did he need extra tubes, all he needed was basic tools to install the kit.
Did he turn on the water supply and flush the water line, before he hooked it up to the new fill valve ?
Once he hooked everything up, did you try to dispense water, from the dispenser, it takes at least a gallon of water to fill and flush the air and debris from the water dispenser system.
Does the icemaker make ice ?
The number you attached, are you available there, during normal EST work hours ?