[Roggy]

I was getting an F3 Fault Code. I replaced the Sensor. I still get an F3 Fault Code. I replaced the Control Board. I still get an F3 Fault Code. I had a Service Tech come out and he found a part that he could not identify which he says is bad. There is a 3" wiring piece between the plug from the sensor and the Control Board. He says that there is no continuity from one end of the piece to the other. This piece has a 2-prong "female" plastic plug on one end (plugs into the lead coming from the Sensor) and a 3-prong "female" plastic plug on the other (plugs into the Contol Board - only 2 holes are used, the two outside holes). Inbetween the two plugs are two wires. One is a blue insulated wire and the other looks to be bare with an oversized insulation on it that reads "NE 105C L.T. 600 VW". I am assuming it may have been some type of resistor or something like that. This is the wire that doesn't have any continuity. The Service Tech can't identify it and it's not on the Parts Lists or Drawings. Does anyone know what it is and if so where can I find a new one??? Surely there's one somewhere. I'd hate to buy a new wall oven just because of this little part. HELP!!!