GE front load washerIf I change the front drum, do I need to change the back one too?
My parent's GE washer was making a thumping noise while in the spin cycle. I open the door and found plastic shavings inside of the door gasket at the drain hole. I removed the bottom panel and removed the drain filter, it was clogged with money, a key and many plastic shavings. The water must not have been emptying completely out of the clothes and caused the drum to go off balance. When the machine ran off-balanced, it wore into the plastic housing for the front drum. I plan to change the front tub (AP3884038) housing, but my question is, "Should I replace the rear tub?" (AP3884028). I can't tell if the bearing or the seal in the rear tub housing is in good shape or not, and I don't want to change the front and then have issues with the rear in a few months. Is there a way that I can check this out???
Ads By Google