View Single Post
  #2 (permalink)  
Old 07-24-2008, 09:47 PM
Earl Dryer Earl Dryer is offline
Junior Member
 
Join Date: Apr 2008
Posts: 29
Earl Dryer is on a distinguished road
Default

1. Does icemaker fill with water and is the mold empty?
2. Is there Ice in the mold with the ejector fingers touching the cubes but not ejecting?

1. If no fill & empty mold Remove the white cover from the front of the ice maker then place a jumper wire between test point T & H for about 3 to 5 second this bypasses the thermostat and the water should fill Listen for the solenoid to buzz. This also resets the icemaker. Icemaker could go on and function nornally or stall at eject or fill again. If it does the t-stat is gone get a new unit.
2. If yes, The heater is probably out replace the unit (Most common failure)
Reply With Quote
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17