View Single Post
  #2 (permalink)  
Old 08-30-2010, 05:08 PM
LouVillian LouVillian is offline
Junior Member
 
Join Date: Aug 2010
Posts: 2
LouVillian is on a distinguished road
Default

Quote:
Originally Posted by LouVillian View Post
I have a Roper Electric Dryer Model REX3514RQ1. Its about 5 years old. It runs fine but no heat. My guess is the heating element. I first checked the Fuse box to make sure both fuses were in the on position. Turned them off then back on to be safe. Took the back off the dryer and disconnected the High Limit Dryer Switch and ran a wire to each Unhooked wire to test that. The dryer still did not heat up while this was done. Have i tried everything? Is it more then likely the Heating Element? Is there a way to sure fire check the Heating element?

Thanks in adavance for any help!

Pulled the Heating Element out and noticed the Bottom Coil is cracked in the middle. Im guessing this should correct my problem if replaced. If any techs can share some light it would be appreciated.
Reply With Quote
 

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17